Ultracrete Instaband Eco: Thermoplastic Overbanding Tape

Instaband ECO: Thermoplastic Overbanding Tape

Instaband ECO is a thermoplastic over-banding tape, which has been designed for application around pothole repairs, it prevents water ingress and progressive fretting around pothole reinstatement’s. It has been HAPAS Approved since 2012 and prevents water ingress immediately, prolonging the life of your repair. Instaband ECO is ideal for use as a complete system, with SCJ Cold Joint Spray, Instant Road Repair, and Permanent Pothole Repair – PPR.

• Quick and easy to apply
• Fast installation
• Open to traffic: 10 minutes
• Elastic qualities accommodate thermal movement
• 60 SRV
• No waste – cut as required
• Manufactured using 100% recycled glass particles
• Size: 5 metre rolls, 35mm wide x 3mm depth
• Available in Black and Red (For read call us on ☎️ 0330 122 1025)
• NBS Source registered for ease of specification
• UltraCrete Accredited Reinstatement Specification (UCARS) product
• Need a larger quantity? Click here for our 12 roll Instaband ECO Box deal:  

Applications

UltraCrete Instaband ECO is a thermoplastic, skid resistant over-banding and crack sealant tape designed for application to asphalt roads to prevent water ingress and progressive fretting, which leads to road structural failure.

Technical

Instaband ECO is supplied in 5 metre rolls, 35mm wide (40mm wide when installed) x 3mm depth for easy handling. It has an anti-skid SRV of 60 and conforms to the requirements of S11.7 (SRV minimum 55) of the specification for the Reinstatement of Openings in Highways (SROH).

Preparation

Instaband ECO is easy to apply on asphalt surfaces, always ensure that the area of application is clean, dry and free from dust, chemicals and any significant oil substances. If application to concrete is required the area should be primed. Please ensure that the area has completely cooled before the primer is applied.

Application

Preheat the surface making sure it is completely free from moisture. Remove Instaband ECO from its protective wrapping and roll out on to the road surface, beaded side up. Once in place, heat the Instaband ECO with a propane torch. The heat should be applied from a distance of approximately 200-400mm (8”-16”) from the material. Heat in a slow even sweeping motion making sure you do not spot-heat any area, as this may scorch the material causing discolouration. Instaband ECO must be heated until the material starts to bubble and melt. Depending on air temperature, Instaband ECO will cool down and harden within 5-10 minutes of installation. When this has occurred, check for correct installation by trying to lift parts of the material at the edges using a knife or a chisel. If this can be lifted, simply reapply heat until adequate bonding has occurred.

Precautions

When the weather is warmer and the road temperature higher, the setting time for the material may be slightly longer. Do not use Instaband ECO® when it is raining or snowing. Ensure surfaces treated with salt or de-icers are fully washed as Instaband ECO® will not bond with these substances. Do not unpack more material than is necessary, as materials will harden when exposed to UV rays. Take care in excessively cold weather, as the material will become brittle.